Installing The Rapidrails Slide Assemblies; Figure - Dell PowerVault 725N Rack Installation

F i g u r e 1 - 4 .
tape on
vertical rail

Installing the RapidRails Slide Assemblies

At the front of the rack cabinet, position one of the RapidRails slide assemblies so that
1
its mounting-bracket flange fits between the marks or tape you placed on the rack (see

Figure 1-5).

The mounting hook on the slide assembly's front mounting bracket flange should
enter the top hole between the marks you made on the vertical rails.
Push the slide assembly forward until the mounting hook enters its respective square
2
hole on the vertical rail, and then push down on the mounting-bracket flange until the
mounting hooks seat in the square holes and the push button pops out and clicks (see
Figure 1-5).
At the back of the cabinet, pull back on the mounting-bracket flange until the
3
mounting hooks are located in their respective square holes, and then push down on
the mounting-bracket flange until the mounting hooks seat in the square holes and
the push button pops out and clicks.
Repeat step 1 through step 3 for the slide assembly on the other side of the rack.
4
1-8
Rac k I n s t a l l a t i o n G u i d e
M a r k i n g t h e V e r t i c a l R a i l s