Bosch NWD-455V03-20P Operating Instructions Manual page 92

92 en | Configuration via the browser
NOTICE! A firmware update resets all camera parameters to
their factory default values. If you wish to retain the old values
i
first save the configuration by performing a configuration
download. After the firmware update you can reload your
parameter values by performing a configuration upload.
To update the firmware:
1. First, save the update file to the hard disk.
2. Enter the full path for the update file in the field or click
Browse... to locate and select the file.
3. Click Upload to begin transmission to the unit. The
progress bar allows you to monitor the transfer.
NOTICE!
i
Installing new firmware and reconfiguring the camera takes
several minutes.
The new firmware is unpacked and the Flash EPROM is repro-
grammed. The time remaining is shown by the message going to
reset Reconnecting in ... seconds. After the upload is com-
pleted successfully, the unit restarts automatically.
If the operating status LED lights up red, the upload has failed
and must be repeated. To perform the upload, you must switch
to a special page:
1. In the address bar of your browser, after the unit IP
address enter
/main.htm (for example 192.168.0.80/main.htm).
2. Repeat the upload.
Configuration download
You can save configuration data for the camera to a computer
and load saved configuration data from a computer to the unit.
1. Click Download; a dialog box appears.
2. Follow the instructions to save the current settings.
V 1.0 | 2006.12 Operating Instructions
FlexiDome IP
Bosch Security Systems