Bosch NWD-455V03-20P Operating Instructions Manual page 72

72 en | Configuration via the browser
Number of destination IP address
Here you assign the numbering for the IP addresses to be con-
tacted in the event of an alarm. The unit contacts the remote
locations one after the other in the numbered sequence until a
connection has been established.
Destination IP address
For each number, enter the corresponding IP address for the
desired remote location.
Destination password
If the remote location is password protected, enter the pass-
word here.
Only ten passwords can be defined here. You can define a gen-
eral password if more than ten connections are required, for
example when connections are initiated by a controlling system
such as VIDOS or BVMS. The camera connects to all devices
protected by the same general password. To define a general
password:
1. Select 10 in the Number of Destination IP-address list
box.
2. Enter 0.0.0.0 in the Destination IP-address field.
3. Enter the password in the Destination password field.
4. Set the user password of all the devices to be connected
to this password.
Setting destination 10 to the IP-address 0.0.0.0 overrides its
function as the tenth address to try.
Destination port
Choose the browser-port, depending on the network configura-
tion. Port 443 for HTTPS connections is only available if the On
option in SSL encryption is selected.
SSL encryption
SSL encryption can be used to protect data, such as the pass-
word used for establishing a connection. If you select On, only
encrypted ports are available for the destination port. SSL
encryption must be activated and configured on both sides of a
V 1.0 | 2006.12 Operating Instructions
FlexiDome IP
Bosch Security Systems