5025-2xx, 4xx
Operator panel display blank, printer beeps five times and pauses
Step
Questions / actions
1
Turn the printer off, and remove the rear
shield. See
"Rear shield removal" on
page
4-11.
Turn the printer on, and verify the following
values at JOPP1 on the controller board:
Pin
Are all these values approximately correct?
2
Turn the printer off, and check for continuity in
the operator panel cable.
Note: Remove the three screws holding the
operator panel, and place it facedown on top of
the printer. The cable connector pins will be
exposed and easier to contact.
Do all the conductors indicate continuity?
2-38
Service Manual
JOPP1
Value
1
0 V dc
2
+5 V dc
3
0 V dc
4
Ground
5
+5 V dc
6
+3.3 V dc
7
Ground
Yes
Go to step 2.
Replace the operator panel.
See
"Operator panel
removal" on page
4-9.
No
Replace the controller
board. See
"Controller
board removal" on
page
4-19.
Replace the front cover
assembly. See
"Front
cover assembly removal"
on page
4-2.