Table of Contents
Advertisement
3.
Serial ATA connectors (7-pin SATA1, SATA2, SATA3, SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, and RAID 5 configuration using the Intel
Technology or RAID 0, RAID 1 and RAID 0+1 configuration using the LSI
MegaRAID
utility embedded in the Intel
®
These connectors are set IDE mode by default. In IDE mode, you can connect
Serial ATA boot/data hard disk drives to these connectors. If you intend to create
a Serial ATA RAID set using these connectors, set the Configure SATA as item
in the BIOS to [RAID]. See section "4.3.5 IDE Configuration" for details.
®
P5BV
P5BV SATA Connectors
Use only two Serial ATA RAID connectors for each RAID 0 or RAID 1 set.
ASUS P5BV Series
ICH7R Southbridge.
®
SATA4
SATA2
SATA3
SATA1
Matrix Storage
®
2-25
Advertisement
Table of Contents
