Intel BB5000XALR Specification page 5

Monthly Specification Update
26. Failures seen installing to a SATA drive when SATA is set to "Legacy" in the BIOS
setup 14
27. System hangs after disabling on-board video in the BIOS setup .......................... 14
28. The SMBIOS entry point may not be visible under certain hardware configurations14
29. Intel® Embedded Server RAID Technology II and I/O module IRQ routing conflict15
30. SuSE* Linux Enterprise Server may not install successfully with Intel® Embedded
Server RAID Technology II enabled ....................................................................................... 15
31. Red Hat* Enterprise Linux 4 and BIOS setup display a different L2 cache size for
the Quad-Core Intel® Xeon® processor 5300 Series ............................................................. 16
32. Change Logo Utility causes BIOS corruption ........................................................ 16
33. Microsoft Windows System Event Viewer* may record Error Event with ID 11 ..... 16
34. After the system reboots, the POST screen may generate "NMI has been received
- System Halted" message ..................................................................................................... 17
35. Intel® RAID Web Console 2 utility displays "Unexpected Sensor" warning
message in Microsoft Windows* operating system ................................................................ 17
36. Random drives may go offline when a sixth drive is installed and Intel® Embedded
Server RAID Technology II is enabled in the Intel® Server System SR2500ALBRP .............. 18
37. Intel recommends enterprise-class hard drives for use with Intel® Server Systems18
38. Dual Gigabit Expansion Module may not properly reset ....................................... 18
39. SAS drive in a ROMB RAID 5 may drop offline during a reboot in the Intel® Server
System SR2500PALLX .......................................................................................................... 19
40. Intel® Server System SR2500ALLX sixth hard drive filler panel is difficult to
remove 19
41. SuSE* Linux Enterprise Server unable to boot after basic installation .................. 20
42. Drives may not be detected or may go offline in the Intel® Server System
SR2500ALBRP when operating at SATA 3GB/s data rate ..................................................... 20
43. New versions of BMC firmware with previous versions of BIOS cause system
POST failure .......................................................................................................................... 21
44. Intel® Server System SR2500ALLX may operate louder than expected .............. 21
45. Red Hat* Enterprise Linux may report the wrong processor speed ....................... 21
46. The SuSE* Linux Enterprise Server 10 driver for SAS HW RAID causes unwanted
error logs during installation ................................................................................................... 21
47. IERR or thermal trip event reported in System Event Log (SEL) after system power
on 22
48. USB device generates "The following boot-start or system-start driver(s) failed to
load: i8042prt" error message in Microsoft Windows* operating systems ............................... 23
49. Microsoft Windows* and Intel® RAID Web Console II report an error when the
ASR2500SATAPE kit is used ................................................................................................. 23
50. System may log IERRs when running certain Red Hat* Enterprise Linux versions
on the Intel® Server Board S5000PAL with video driver ati_drv.o 6.5.6 ................................. 23
51. Microsoft Windows* operating systems installed without a service pack will display
blue screen with BIOS 79 and 81 ........................................................................................... 24
52. Sluggish system performance may be experienced with BMC 60......................... 25
Enterprise Platforms and Services Marketing
v