Remote Control Connection - Yamaha YMC S21 - neoHD AV System Owner's Manual

You can control your TV and the components connected to this unit using the remote control of this unit by connecting
the IR flashers between this unit and the components, and by setting the IR codes. You can also turn on or off the TV and
the components in conjunction with the operation of this unit.
TV
Source device
■ Connections
TV
SENSOR
Source device
SENSOR
■ Settings
Make the following settings.
• The IR setting for your TV
Initial Setup ☞ P. 10, Setup Menu ☞ P. 42
• The IR settings for the components connected to this
unit
Initial Setup ☞ P. 10, Setup Menu ☞ P. 39
• Other settings
"Initial Screen" menu ☞ P. 43
8
En
Remote control connections
Note
While this unit is turned on, this unit passes all remote control
codes (of the TV and source devices) input at the remote control
sensor to the TV and the devices via IR flashers.
IN OUT
Connect the plugs of the supplied IR flashers to the
1
USB
REMOTE CONTROL OUT 1 and 2 jacks, and attach the
3 2
REMOTE CONTROL
flashers to the remote control sensors of your TV and the
AC IN
R
components connected to this unit. The supplied IR flashers
FRONT
SPE
have two flasher heads each. Both flasher heads function
equivalently. You can also connect a commercially available
To other
flasher to the REMOTE CONTROL OUT 3 jack.
source devices
y
• You can connect the IR flashers to any of the REMOTE
CONTROL OUT 1, 2, and 3 jacks because the same signal is
output.
• Refer to the owner's manual of the TV and source devices for the
position of the remote control sensor.
■ Operations
To control the TV and the components connected to this
unit, aim the remote control at the remote control sensor of
this unit.
Enjoying the contents on an external device ☞ P. 20
About the REMOTE CONTROL IN jack
You can connect a commercially available IR receiver
to this jack to control this unit even if it is concealed.
Place the IR receiver within sight.
About the remote control codes
This unit equips built-in remote control codes for most
functions of many audio/video components. The
remote control codes can be "learned", assigning them
to the remote control of this unit or to the virtual
remote control (☞ P. 21). The unit transmits the proper
codes to the different devices through the IR flasher.
Peel off the wax paper
before attaching the flashers.