I3.2 Rack Jamming; I3.3 Wash Phase Stop; I3.4 Temperature Display - Electrolux 534074 Instruction Manual

Electrolux rack-type dishwasher instruction manual
Hide thumbs Also See for 534074:
Table of Contents

Advertisement

To start washing select one of the start keys ("C" or "D" -
Table 2).
The machine starts washing and the display shows:
- prewash temperature ("F" - Table 2)
(if present in machine)
- wash temperature ("G" - Table 2)
- boiler temperature ("H" - Table 2).
If racks are not inserted after a few seconds, the con-
veyor continues operating whereas the pumps stop and
the display shows:
InSErt
-
("F" - Table 2)
- wash temperature ("G" - Table 2)
- boiler temperature ("H" - Table 2).
Clean and arrange the dirty dishes on the racks as indi-
cated in par. I3.5 "Loading dishes on racks".
Insert a rack with dishes in the dishwasher infeed and
allow the automatic feed system to take it to the various
wash zones.
An acoustic signal sounds when a rack reaches the end
of the conveying system; the display shows:
rEM
-
(Remove) ("F" - Table 2)
- wash temperature ("G" - Table 2)
- boiler temperature ("H" - Table 2).
Remove the rack and load new racks with dirty dishes at
the dishwasher infeed.
IMPORTANT!
The Customer must appraise, according
to the current regulations in the country
of use, the risk concerning manual han-
dling of loads by operators, on the basis
of ergonomic aspects and the weights to
be handled, as well as the work loads.
I3.2
Rack jamming
If the dishes are not correctly loaded on the racks, jam-
ming may occur inside the tunnel, and the display
shows:
SEE
-
("F" - Table 2)
itEM
-
("G" - Table 2)
inSidE
-
("H" - Table 2).
Switch the machine off, open the doors and eliminate the
cause of jamming.
I3.3
Wash phase stop
Press the Stop key ("B" - Table 2) to stop the wash
phase.
Washing stops, and the machine stays on standby mode
(Ready). Press a start key to restart washing.
I3.4
Temperature display
The prewash temperature, if present in the machine, can
be displayed during all the above phases by selecting
the increase key ("O" - Table 2):
the following is displayed for 30 seconds
- prewash temperature ("F" - Table 2)
- wash temperature ("G" - Table 2)
- boiler temperature ("H" - Table 2).
:
37

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents