J.2
Daily activation
IMPORTANT
Refer to the chapter "I Start up" before using the
dishwasher.
Turn clockwise the switch disconnector from position "O" to "I"
to power the machine.
• During the filling phase, the screen, continuously, shows the
exact step of the filling phase.
1
Animated water level icon of the tanks
• During the heating phase, the screen, continuously,
updated its status.
1
Animated thermometer icon
2
Animated water level icon of the tanks
• At the end of the filling and heating phase, the screen shows
for some seconds the machine icon with a tick.
The tank and the boiler of the dishwasher are filled and the
set temperatures have been reached.
• After some seconds, the machine is ready to use. You can
start the washing cycle and take under control the washing
temperature of the tank and the boiler.
1
65°C
1
Temperature of the water inside the wash tank
2
Wash speed
3
Temperature of the water inside the boiler
1
1
2
2
3
82°C
For normally soiled
dishes
• To start the washing cycle, touch the wash speed icon. The
same icon changes in pause icon
pause the washing cycle.
65°C
82°C
IMPORTANT
To obtain best washing results, wash three empty
racks to allow all the equipment to reach the
working temperature.
J.3
Wait rack
• If after the start of the washing cycle, the operator does not
insert any racks, for a while, the conveyor continues
operating while the pump stops and the screen shows to
insert the rack.
• Insert a new rack to restart the washing cycle. The screen
comes back in the ready status.
65°C
J.4
End limit switch activated
• When a rack reaches the end of the conveying system, it
activates the "end limit switch" device. The machine stops
immediately to work and the screen shows:
• Remove the rack, after some seconds the machine is ready
to work and washing cycle starts again. The screen comes
back in a "ready status".
65°C
. Touch it again to
65°C
82°C
82°C
82°C
17