I Intended Use Of Machine; I1 Correct Use; I2 Features Of Operators On Machine; I3 First Purpose - Electrolux EUC40G1 Instruction Manual

I Intended Use of Machine
I1 Correct Use
This equipment is specially designed and
improved to achieve excellent performance and
efficiency. It must be for the designed purpose, i.e.
used for dish washing with water and special
detergent. Any other purposes are considered as
improper use.
I2 Features of Operators on Machine
A qualified operator for normal use of machine
must at least:
•
have knowledge
experiences of machine operation;
•
be able to read and understand the contents
of the Manual;
•
be able to understand the drawings, signs
and icons;
•
have technical knowledge for following the
Manual;
•
knowledge of occupational health and safety
regulations.
In case of obvious fault (e.g. short circuit, faulty
lead of terminal block, faulty motor, worn electric
cable sleeve, etc.), a qualified operator for normal
use of machine must at least:
•
shut down the machine by press the power
supply key;
•
disconnect the breaker of the equipment;
•
close the water supply valve and shut off the
water supply of the machine.
I3 First Purpose
Without dishes, perform two cycles, flush to
discharge any industrial grease remained in the
water tank and pipes.
I4 Daily Activation of Machine
•
Ensure that the spraying arm, rinsing arm,
lifting cup, filter of the machine are installed
for technology and
in place and the equipment door is closed.
•
Open the water supply valve;
•
Switch on the circuit breaker "G" (refer to
"E7");
•
Press the "Start" key for 2 s then press again
for 2 s under the "ON" condition.
•
The machine is being filled and heated when
the indicator light of operating condition is
ON in green.
I5 Washing Cycle
The washing
operation performed with hot water and detergent
at 60 ℃ at least and the flushing operation
performed with hot water and quick-dry agent at
82 ℃ at least.
This machine may operate in 3 modes, including
"Washing Cycle 1", "Washing Cycle 2", "Washing
Cycle 3", of which washing cycle times and
washing temperatures are different (see time
table).
Time table
Washing Washing
cycle cycle time
Washing
Cycle 1
Washing
120
Cycle 2
Washing
180
Cycle 3
30
cycle includes the
Main
washing
temperature
90 55
60
65
washing
Rinsing
temperature
82
82
82