Setting Up The Indicator; Parameter Settings And Calibration - A&D FS-D Setup Instructions

4-4. Setting Up the Indicator

Clamp
Clamp
Display stand
Connect the main power cord to an outlet that has an earth ground terminal. You
may use the earth terminal on the rear side of the display to ground the indicator.
If necessary, adjust the viewing angle of the display by loosening the 2 clamps,
changing the angle and re-tightening the clamps.
The Display stand can be secured on a table or flat surface using screws (not
supplied). It can be also used as a wall-mounting bracket. See "11-3. Dimensions"
about the dimensions of the mounting holes.

4-5. Parameter Settings and Calibration

When a platform scale is initially set up, it is necessary to set some parameters and
calibrate it using a calibration weight.
See "6. FUNCTION PARAMETER SETTINGS" to set parameters and "7. CALIBRATION"
to calibrate the scale.
Earth terminal
Earth
terminal
Display stand
(Wall-mounting bracket)
7
To the wall