A&D TM-2430 Instruction Manual page 18

Mode III Settings
Set up procedure
Before you enter into mode III, read the procedure below. Also, refer to the
example on the next page for the setting procedure.
Each blocks starting time must match the previous blocks finish time.
The end of block 6 automatically equalizes to start time of the block 1.
If you enter the block 1 start time in any other block, these parameters are
saved and this sequence is finished.
When selecting 120 minutes for the current frequency, you must adjust the
start time of the next block so that the current block fits a multiple of 120
minutes. If you do not fit to the next start time, an error code is displayed.
The recorder displays
When you enter the sequence of mode III settings, the recorder initializes each
start time to the start time of block 1 and each frequency to "-" (not used).
To read the current settings, press the
Display & key
Sign of setting parameters
for automatic measuremnt
Items
Sequence
number
01
02 - , 5, 10, 15, 20, 30, 60, 120 minutes
03
04 - , 5, 10, 15, 20, 30, 60, 120 minutes
05
06 - , 5, 10, 15, 20, 30, 60, 120 minutes
07
08 - , 5, 10, 15, 20, 30, 60, 120 minutes
09
10 - , 5, 10, 15, 20, 30, 60, 120 minutes
11
12 - , 5, 10, 15, 20, 30, 60, 120 minutes
13
The "-" means "not used".
Selection for the Automatic Measurement
as 60 minutes and
Sequence number
Parameter
Parameters (monitor)
0 ~ 23 o'clock
0 ~ 23 o'clock
0 ~ 23 o'clock
0 ~ 23 o'clock
0 ~ 23 o'clock
0 ~ 23 o'clock
0 ~ 23 o'clock
START STOP
START AUTO
STOP ON/OFF
Selecting a sequence number
Meaning
Start time of first block
Frequency of first block
Start time of second block
Frequency of second block
Start time of third block
Frequency of third block
Start time of fourth block
Frequency of fourth block
Start time of fifth block
Frequency of fifth block
Start time of sixth block
Frequency of sixth block
End of sixth block
Page 16
as 120 minutes.
key in this sequence.
Selecting a
parameter
Initial value
Initializing the recorder