A&D TM-2430 Instruction Manual page 16

Steps for setting the display and clock
This explanation uses the following examples.
ex. After reset, The measurement value is not displayed.
The clock is adjusted to 1997/ 05/ 27 14:28.
Step 1 Press and hold the
The recorder displays
and clock.
Step 2 Press the
(A selection where a clock is displayed only in automatic
measurement)
Step 3 Press the
Step 4 Press the
Step 5 Press the
Step 6 Press the
Step 7 Press the
Step 8 Press the
Step 9 Press the
Step10 Press the
Step11 Press the
Step12 Press the
the recorder displays the clock.
Parameters for the Display and Clock
START STOP
AUTO ON/OFF key so as to display
START STOP key. The current year is displayed .
START STOP
key. The current month is displayed.
AUTO ON/OFF
key to display 5 (for May).
START STOP
key. The current day is displayed.
AUTO ON/OFF key to display 27 (27th day).
START STOP key. The current hour is displayed.
AUTO ON/OFF
key to display 14 (14th hour).
START STOP
key. The current minute is displayed.
AUTO ON/OFF
key to display 28 (28th minute).
START STOP key to save these parameters. Then
Page 14
key for approx. 6 seconds.
for adjusting the display
START STOP
AUTO ON/OFF
.
START STOP
START STOP
AUTO ON/OFF
START STOP
AUTO ON/OFF
START STOP
AUTO ON/OFF
START STOP
AUTO ON/OFF
START STOP
Initializing the recorder