Powering On/Off The Projector; Powering On The Projector - 3M SCP715 Operator's Manual

3M™ Super Close Projection System
Test Pattern
•
Turn on the
projector first and
then the signal
sources.
© 3M 2008. All Rights Reserved.

Powering On/Off the Projector

Powering On the Projector

1. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn red.
2. Turn on the lamp by pressing "Power/Standby" button on the
control panel. And the Power LED will turn blue.
3. Turn on your source (computer, notebook, video player,
etc.). The projector should automatically detect your source
within "Management" menu; check that "Input Source" has
been set to "Auto Searching".
To access the built-in test pattern, please press the "Blank"

button, then up arrow.
If you connect multiple sources at the same time, use the

"Source" button on the control panel or direct source key on
remote control to switch.
1
Power/Standby
1
Installation
15