Powering On/Off The Projector; Powering On The Projector - 3M DX70i Operator's Manual

Installation
Test Pattern
Turn on the
then the signal
sources.
12

Powering On/Off the Projector

Powering On the Projector

1. Remove the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will turn red.
3. Turn on the lamp by pressing "Power/Standby" button on the
control panel.
4. Turn on your source (computer, notebook, video player,
etc.). The projector will detect your source automatically
within "Management" menu; check that "Source Lock" has
been set to "Lock".
If the screen displays "No Signal", please make sure the
signal cables are securely connected.
To access the built-in test pattern, please press the "AV
Mute" button, then up arrow.
If you connect multiple sources at the same time, use the
"Source" button on the control panel or direct source key on
remote control to switch.
1
Lens Cap
3M™ Digital Projector
And the Power LED will turn green.
2
Power/Standby
© 3M 2008. All Rights Reserved.
RE-SYNC
POWER/
STANDBY