3M SCP715 Operator's Manual page 8

3M™ Super Close Projection System
© 3M 2008. All Rights Reserved.
Do not attempt to service the projector other than performing
•
routine lamp replacement. Service should only be performed by
a 3M authorized service provider. Aside from the projection lamp
assembly, there are no serviceable parts inside the unit.
Contact a 3M authorized service provider for service.
•
Do not modify this projector.
•
Do not allow water or other liquids to enter the projector.
•
Do not operate this projector in wet environments or outdoors.
•
Do not use this projector around unsupervised children.
•
Replace power cord if damaged.
•
Contact a 3M authorized service provider if the projector be-
•
comes damaged.
Connect this projector into a grounded outlet.
•
Use a grounded extension cord with a rating at least equal to that
•
of the projector.
Use only the 3M brand wall mounting hardware kit if wall mount-
•
ing is desired.
- Installation of 3M wall kit must only be performed by qualified
personnel.
- Adhere strictly to the proper installation procedure as outlined in
the installation instructions when installing the 3M wall kit.
Always operate the unit on a flat, sturdy, and horizontal surface.
•
Before operating, please read owner's manual. Do not remove
•
screws except lamp cover screws. Do not block venting open-
ings.
WARNING
Usage Notice
3