Usage Notice
4
Lamp replacement caution. Before removing the screws, discon-
•
nect the power cable. Hot surface inside. Allow 1 hour to cool
before replacing the lamp. Handle with care. Risk of explosion.
See Owner's Manual.
Unplug the projector from the electrical outlet and allow the lamp
•
to cool for 60 minutes before replacing the lamp.
Wait at least 30 minutes for the lamp assembly to cool before
•
replacing.
Always handle the fragile lamp module with care.
•
In the event of a lamp rupture, call a 3M authorized service pro-
•
vider for repair. Ruptured lamp is not user serviceable.
Ventilate the area where the lamp rupture occurred. The lamp
•
operates at high pressure and temperature.
Replace the lamp module when the lamp replacement message
•
appears.
Never replace the lamp module with a previously used lamp
•
module.
Hg: Lamp contains mercury. Don't throw in trash. Dispose ac-
•
cording to local, state, or federal laws. See www.lamprecycle.org
or call 1-800-328-1371.
Wash your hands thoroughly if contact with ruptured lamp debris
•
has taken place.
Ventilate the area where the lamp rupture occurs. The lamp oper-
•
ates at high temperature.
3M™ Super Close Projection System
WARNING
© 3M 2008. All Rights Reserved.