3M™ Super Close Projection System
© 3M 2008. All Rights Reserved.
Use only battery type AA.
•
- Orient the batteries plus (+) and (-) terminals of the batteries ac-
cording to the markings found on the remote control.
- Do not leave the battery in the remote for an extended period of
time.
- Do not heat, disassemble, short, recharge, or expose to fire or
high temperature.
- Do not carry batteries loose in your pocket or purse.
- Avoid eye and skin contact in the event that battery would leak.
- Do not mix used and new batteries.
Dispose of exhausted batteries in accordance with applicable
•
federal, state and local regulations.
Avoid looking directly into projector lens while the lamp is on.
•
Keep the battery and battery cover away from children and pets.
•
Changes or modifications not expressly approved by the manu-
•
facturer could void the user's authority, which is granted by the
Federal Communications Commission to operate this computer.
Do:
Turn off the product before cleaning.
Use a soft cloth moistened with mild detergent to clean the
display housing.
Disconnect the power plug from AC outlet if the product is not
being used for a long period of time.
Don't:
Block the slots and openings on the unit provided for ventilation.
Use abrasive cleaners, waxes or solvents to clean the unit.
Use under the following conditions:
- In extremely hot, cold or humid environments.
- In areas susceptible to excessive dust and dirt.
- Near any appliance that generates a strong magnetic field.
- In direct sunlight.
WARNING
Usage Notice
5