Connecting To Gas - Parkinson Cowan U03059 Owners Handbook And Installation Instructions

INSTALLATION INSTRUCTIONS

CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible connection only. Supply piping
should not be less that R³/8. Connection is made to the Rc ½ (½" B.S.P.) female threaded entry pipe
located just below the hotplate level on the rear left hand side of the appliance. NOTE: ONLY LIQUID
SEALANTS TO BE USED WHEN INLET GAS PIPE IS FITTED I.E.: DO NOT USE P.T.F.E. SEALANT
TAPE. Check for gas soundness after connecting to the gas supply. The gas bayonet connector must be
fitted in the shaded area indicated in Fig.3. Take into account that it must be possible to pull the
appliance forward sufficiently. The hose must not get caught on the stability bracket.
IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH BS. 669 CURRENT EDITION.
fig 3.