Replacing The Hob Burner Parts; Cleaning The Outside Of The Cooker - Parkinson Cowan U03059 Owners Handbook And Installation Instructions

REPLACING THE HOB
BURNER PARTS
1. Crown to burner body
Do not force the crown on to the burner body.
Make sure the hole in the crown is over the
electrode. Check that the location pegs sit in
the slots in the body. When the crown is in this
position let it fall freely on to the body. Check
that the crown can be moved slightly from side
to side.
2. Cap to crown
Place the burner cap centrally on top of the
crown with the enamel side up. Move sideways
and front to back to check the cap is properly
fitted.
3. Check for ignition
If a burner will not light, check the crown and
cap positions.
TO REPLACE THE PAN
1. Position the location pegs on the pan support
over the location points on the hotplate and
gently ease the pan support into place.
Ensure the pan supports have been
carefully dried and are correctly fitted
before use.
REPLACING THE ULTRA
RAPID BURNER CAP
The Ultra Rapid burner cap is in two parts.
Ensure the aluminium part is fitted correctly
before placing the enamelled cap in the same
orientation on top. Move the cap sideways and
front to back to check the cap is properly fitted.
CLEANING THE OUTSIDE OF
THE COOKER
Do not move the cooker by pulling the
door handles.
See below on how to move your
cooker safely.
DO NOT use abrasive cleaning materials or
scourers on the outside of the cooker as you
will damage the finishes.
Regularly wipe over the control panel, oven
doors, sides and plinth using a soft cloth well
wrung out in warm water to which a little
washing up liquid has been added.
Do not use abrasives of any kind on
the controls or handles as damage to
the plated finish will occur.
SUPPORTS
location peg
location point
location
peg
location
point
location peg
pan
support
burner cap
crown
location point
electrode
body
location peg
pan support
enamelled
burner cap
aluminium
burner cap
burner crown
location point
electrode
burner body
29