Location Of Appliance - Parkinson Cowan U03059 Owners Handbook And Installation Instructions

INSTALLATION INSTRUCTIONS

LOCATION OF APPLIANCE

This appliance is not for commercial use and must only be installed in domestic premises.
This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom or
shower room. This is a type 'X' appliance, it is essential that the appliance is positioned as stated below
i.e. shelves, wall cabinets and cooker hoods must be fitted a minimum of 750mm directly above the top
of hotplate (or greater for cooker hoods if recommended by manufacturers instructions) and 400mm
above the hotplate when fitted in line with the outside of the appliance. If the units are intended to be
fitted adjacent to the appliance but less than 400mm above the hotplate, then a minimum space of
100mm must be maintained between the sides of the unit and the appliance. The hotplate must be a
minimum of 5mm above the height of adjacent units. Curtains must not be fitted immediately behind the
appliance or within 150mm of the sides of the hotplate. If fitted next to or between two base units a
minimum space of 1mm must be left between each unit and the sides of the appliance. The levelling feet
fitted to the appliance will achieve a nominal height to hotplate of 907mm - 0mm +3mm.
Note :- L.P.G. cookers MUST NOT be installed below ground level i.e. in a basement or aboard any
boat, yacht or other vessel.
fig 1.