Media Format; Setting Bluetooth Audio (Type A Audio) - Subaru 2013 Legacy, 2013 Outback Owner's Manual

5-40
Audio
NOTE
. The Bluetooth
®
audio function may
not operate properly under the follow-
ing conditions.
– The device is turned off.
– The battery of the device has run
down.
– The device is not connected to
the system.
– The device is behind the seat or
in the glove box.
– A metal material is covering or
touching the device.
. Depending on the type of device that
is used, operation and sound volume
may be different from normal use of
those devices.
. The sound quality may degrade due
to the influence of the device that is
connected to the system or the circum-
stances of the Bluetooth network.
. When another Bluetooth
simultaneously connected, noise may
be heard.
& Media format
®
Bluetooth audio devices cannot be
connected if they are not compatible with
®
the following Bluetooth profiles.
. A2DP (Advanced Audio Distribution
Profile)
. AVRCP (Audio/Video Remote Control
Profile)
& Setting Bluetooth
(type A audio)
1. Select BT-A SETUP by pressing the
MENU button.
2. Perform the following procedure by
operating the TUNE dial while BT-A is
displayed.
NOTE
You cannot set Bluetooth
driving.
! Registering (pairing) device
NOTE
Only one device can be registered.
1. Select the PAIR AUDIO menu.
If a device is already registered,
®
device is
MEMORY FULL is displayed and the
mode changes to the Bluetooth
audio setting mode.
2. After the passkey is shown on the
display, input the passkey into the device.
If the registering procedure is fin-
ished, PAIRED and the name of the
device are displayed.
If the registering procedure was not
successful, FAILED is displayed.
After the name of the device or FAILED
is displayed, the mode changes to the
Bluetooth
®
audio
NOTE
After the ignition switch is turned to the
"LOCK"/"OFF" position, the registered
device is not automatically connected
to the system even if the ignition switch
is turned to the "Acc" or "ON" position.
! Selecting device
1. Select the SELECT AUDIO menu.
If no devices are registered,
®
audio while
EMPTY is displayed and the mode
changes to the Bluetooth
setting mode.
2. Select the CONFIRM menu.
Then the name of the selected
device is displayed.
If the device is connected, SE-
LECTED is displayed and the mode
changes to the Bluetooth
®
setting mode.
If the device cannot be connected,
FAILED is displayed and the select-
ing procedure was not successful.
! Setting passkey
1. Select the SET PASSKEY menu.
After the currently set passkey is
displayed, a new passkey can be
®
audio setting mode.
®
audio
®
audio