Using The Hands-Free System - Subaru 2013 Legacy, 2013 Outback Owner's Manual

5-48
Audio
by this equipment is in the 2.4
GHz zone. The FH-SS modulation
is employed as a modulation
method. The expected inflicting
interference distance is less than
33 ft (10 m). This equipment uses
a full band and can avoid a band
used by a movable body identifi-
cation device.
& Using the Hands-free system
! Turning on/off the Hands-free mode
1) OFF hook switch
2) ON hook switch
3) Talk switch
To turn on the Hands-free mode, press the
OFF hook switch . To turn off the
Hands-free mode, press the ON hook
switch .
! Preparation for using the Hands-
free system
Before using the Hands-free system, it is
necessary to register a cell phone in the
system. Perform the following procedure
to register a cell phone.
NOTE
. Up to 5 cell phones can be regis-
tered (for type A audio).
. Up to 6 cell phones (including Blue-
®
tooth audio devices) can be registered
(for type B audio).
. When the ignition switch is turned to
the "Acc" or "ON" position, the regis-
tered cell phone may be automatically
connected to the system.
! Registering by operating dial
"TUNE" dial:
Type A audio
Type B audio
Select the menus by operating the TUNE
dial.
Type A audio:
1. Press the OFF hook switch
2. Select ENGLISH / FRANÇAIS
operating the TUNE dial.
WELCOME! will then be dis-
played.
3. Press the TUNE dial or the talk
switch .
4. Select the RECORD NAME menu, or
press the talk switch .
5. Say the name to be registered.
6. Select the CONFIRM menu.
After CAR M_MEDIA is displayed,
a pass key will be displayed.
7. Input the displayed pass key into the
cell phone while PKY: **** is displayed.
Type B audio:
1. Press the OFF hook switch
If no cell phone is registered,
Welcome!! is shown on the screen.
In this case, perform the procedure
after step 4.
2. Select the Setup menu.
3. Select the Phone Setup menu.
4. Select the Pair Phone menu.
5. Select the Record Name menu.
6. Say the name to be registered.
.
by
.