Speedometer; Odometer - Subaru 2013 Legacy, 2013 Outback Owner's Manual

3-8
Instruments and controls
! Type B combination meter
1. Turn the ignition switch to the LOCK /
OFF or Acc position.
2. Press the trip knob to show
on the trip meter display.
The display can be switched as shown in
the following illustration by pressing the
trip knob.
1
* : or and
be displayed when the ignition switch is
in the ON position.
2
* : MT models only
3. To change the current setting, press
the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
. Your vehicle's initial movement
setting of the meter/gauge needles
has been set for activation "
the time of shipment from the factory.
. It is not possible to change the initial
or
movement setting of the meter/gauge
needles when the ignition switch is in
the "ON" position. Change the setting
when the ignition switch is in the
"LOCK"/"OFF" or "Acc" position.
& Speedometer
The speedometer shows the vehicle
speed.
& Odometer
or cannot
" at
Type A
1) U.S. spec. models
2) Except U.S. spec. models
Type B
This meter displays the odometer when