Unlocking The Rear Gate (Outback); Vehicle Finder Function; Sounding A Panic Alarm; Selecting Audible Signal Operation (Models Without "Keyless Access With Push-Button Start System") - Subaru 2013 Legacy, 2013 Outback Owner's Manual

& Unlocking the rear gate
(Outback)
Press the rear gate unlock button to
unlock the rear gate.
An electronic chirp will sound twice and
the hazard warning flashers will flash
twice.
& Vehicle finder function
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the
lock/arm button three times in a 5-second
period will cause your vehicle s horn to
sound once and its hazard warning
flashers to flash three times.
NOTE
If the interval between presses is too
short when you press the lock/arm
button three times, the system may
not respond to the signals from the
remote transmitter.
& Sounding a panic alarm
To activate the alarm, press the PANIC
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. If a
button on the remote transmitter is not
pressed, the alarm will be deactivated
after approximately 30 seconds.
& Selecting audible signal op-
eration (models without
"keyless access with push-
button start system")
Using an electronic chirp, the system will
give you an audible signal when the doors
lock and unlock. If desired, you may turn
the audible signal off.
To deactivate the audible signal, perform
the following procedure. You can also use
the same steps to restore the function.
1. Sit in the driver s seat and shut all
doors and the rear gate.
Keys and doors
2. Press the unlock side of the power
door locking switch.
3. Insert the key into the ignition switch.
4. While holding down the unlock side of
the power door locking switch, pull the key
out and re-insert it into the ignition switch
at least 5 times within 10 seconds after
performing step 2.
5. Open and close the driver s door
within 10 seconds after performing step 4.
6. To indicate completion of the setting,
the hazard warning flashers flash 3 times
and the chirp sounds 3 times.
You may have the above procedure
performed by your SUBARU dealer.
– CONTINUED –
2-21