Internal Cd Rom Drive - HP j6700 - Workstation Service Handbook

Internal CD ROM Drive

To remove the CD ROM drive, do the following:
Figure 4-6. Removing the CD ROM Drive
1. Press sides of connector in back of CD to remove cable
2. Remove two screws
3. Slide CD to front
To replace the CD ROM drive, perform the above steps in reverse.
Removing and Replacing Memory DIMMs
To remove and replace memory DIMMs in the J6700, refer to the memory sequence label
inside the system. Be sure to press the tabs at both ends of the DIMM slots to release the
DIMM, then lift the DIMM out of the slot.
When replacing the DIMMs, press the DIMM into the slot until the tabs on each end snap
into place.
Removing and Replacing the Voltage Regulator Modules (VRMs)
To remove and replace the VRMs, see the section on removing and replacing the system
board.
Chapter 4
1
3
2
Field Replaceable Units (FRUs)
FRU Removal and Replacement
91