Replacing The Front Fan Assembly - Lenovo 7269D7U - Topseller M58e Sff E7500 2.93G 3Gb 320Gb Dvdrw W7p/Xpp Hardware Maintenance Manual

Replacing the front fan assembly

Attention
Do not open your computer or attempt any repair before reading and understanding the "Important safety
information" in the ThinkCentre Safety and Warranty Guide that was included with your computer. To obtain
a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the front fan assembly.
To replace the front fan assembly:
1. Remove the computer cover. See "Removing the computer cover" on page 69.
2. Remove the front bezel. See "Removing and installing the front bezel" on page 70.
3. Disconnect the front fan assembly cable from the power fan connector on the system board. See
"System board connectors" on page 68.
4. The front fan assembly is attached to the chassis by four rubber mounts. Carefully remove these rubber
mounts from the rear of the chassis by breaking them or cutting them with scissors.
5. Remove the front fan assembly out of the chassis.
6. Install the new front fan assembly by aligning the rubber mounts of the front fan assembly with the holes
on the chassis and push the rubber mounts through the holes.
7. Pull on the tips of the rubber mounts until the fan assembly is in place.
90
ThinkCentre Hardware Maintenance Manual