Replacing The Touch Sensor Board - Lenovo 30113RU - IdeaCentre A600 - 3011 Hardware Maintenance Manual

Hardware Maintenance Manual

Replacing the touch sensor board

72
8. Set the new inverter board on the bracket, aligning the two screw
holes on the board to the mounting holes on the bracket.
9. Screw back the two screws on the inverter board.
10. Connect the cables to the inverter board.
11. Replace the inverter board bracket to the chassis aligning the screw
hole on the metal bracket to the mounting hole on the chassis.
12. Screw back the two screws on the metal bracket.
13. Close the system bay.
14. Refer to "Completing the installation".
To replace the touch sensor board
1. Remove the computer cover. Refer to "Removing the computer cover".
2. Open the system bay. Refer to step 2 of the "Replacing the hard disk
drive" section.
3. Remove the wireless keyboard and mouse receiver module. Refer to
"Replacing the wireless keyboard and mouse receiver module".
4. Disconnect the touch sensor board cable from the system board.