Table of Contents
Advertisement
Replacing the Keyboard
To replace the keyboard, complete the following steps:
1. Place the keyboard on a stable flat surface and remove the two adhesive rubber pads from the bottom
of the new keyboard. (If you leave the rubber pads on the keyboard, they will extend into the space
below the tray.)
Attention:
Do not extend the keyboard feet. The flat-panel monitor screen might be damaged if the
feet are extended when the monitor is closed.
2. Turn off the monitor and disconnect the monitor cord.
3. Disconnect the keyboard and mouse connectors from the server or console switch.
4. Unscrew the thumbscrews (if installed), then fully extend the monitor and keyboard tray. Remove the
keyboard-and-mouse cable from the cable-management arm.
5. Carefully lift the front of the flat-panel monitor and raise the monitor to the full upright position.
6. Remove the old keyboard from the keyboard tray.
7. Carefully insert the new keyboard into the tray and route the keyboard-and-mouse cable through the
cord clip on the bottom, through the opening on the right side of the tray, and toward the
20
7316-TF3 17-Inch Flat Panel Rack-Mounted Monitor and Keyboard: Installation and Maintenance Guide
Hide quick links:
Advertisement
Table of Contents
