IBM 7316 - TF1 Rack Console Installation And Maintenance Manual page 20

rack-cabinet mounting flanges.
6. Tighten the two rail-adjustment screws on each of the outer rails that you loosened in step 3 on page
5.
7. Insert the rail-alignment spacer into the slide-rail middle holes. The rail-alignment spacer must wrap
around the rails (top and bottom of the front of the rail) to align them correctly. Tighten the front four
screws; then, remove the spacer.
Note: Do not tighten the four rear slide-rail bracket screws yet.
Rail-alignment spacer
8. Extend the inner part of the rails mounted in the rack, then slide the ball-bearing assemblies forward
to the front of the rails.
6
7316-TF3 17-Inch Flat Panel Rack-Mounted Monitor and Keyboard: Installation and Maintenance Guide