IBM 4910-33S Installation Manual page 28

2. Add Driver to be Installed By WEPOS Install
14
SurePOS 300: Operating System Installation Guide Models 33x and x4x
b. Download the IBM SurePOS 300-33x SATA driver from the IBM Hardware
Support web site at http://www.ibm.com/solutions/retail/store/support.
c. Extract the files from the surepos300-33x-sata2kxp01020057.exe file.
d. In the WEPOS_INSTALL subdirectory, create a subdirectory in the
i386\system32\ subdirectory by the name of Si3112r.
e. Copy the files extracted from the surepos300-33x-sata2kxp01020057.exe file
to this subdirectory. Be sure the TxtSetup.oem file is copied as well. 6. Edit
the TxtSetup.oem file. For your convenience, the entire file is shown in its
own section for you to copy and paste into the TxtSetup.oem file. The
changes to the base TxtSetup.oem file are noted below.
1) The [Disks] section must point to the backslash (\) for the path of the
Tagfile and to the working directory (the last two parameters). i. [Disks]
ii. disk1 = "Silicon Image SiI 3x12 SATALink Driver Installation
Disk",\si3112.sys,\
2) b. The [Defaults] section must point to the [SCSI] section entry. i.
[Defaults] ii. SCSI = Si3112_XP
3) c. The [SCSI] section entry loads the driver
a) [SCSI] ; HwComponent section
b) Si3112_XP = "Silicon Image SiI 3x12 SATALink Controller for
Windows XP/Server 2003", Si3112
c) Si3112_NT = "Silicon Image SiI 3x12 SATALink Controller for
Windows NT 4.0 and 2000", Si3112
4) d. The entire TxtSetup.oem file contents with changes is shown in the
section named TxtSetup.oem.
5) e. Be sure to save the changed TxtSetup.oem file in its original location;
C:\WEPOS_INSTALL\i386\system32\Si3112r\TxtSetup.oem
f. Change directory to the i386\system32 subdirectory.
g. Edit the winpeoem.sif file with the notepad editor For your convenience, this
file is shown in its own section in this document so you can copy and paste
it into the winpeoem.sif file. The changes from the base file are shown
below. Identify the location of the drivers by changing the following keyword
values to the values shown (you can see the contents of the entire file in the
section of this document named Winpeoem.sif:
OemDriverRoot=""
OemDriverDirs=Si3112r
h. Be sure to save the changed winpeoem.sif file in the same location:
C:\WEPOS_INSTALL\i386\system32\winpeoem.sif
Note: This section is based on the Microsoft documentation found on MSDN.
To find this documentation, go to www.microsoft.com and search for
"Adding Drivers to Be Installed by WEPOS Setup".
This step describes the changes necessary for the WEPOS installation process
to install the SATA driver on the hard drive with the operating system.
a. Change the current directory to C:\WEPOS_INSTALL\setup.
b. Create a subdirectory by the name of drivers.
c. Change the current directory to C:\WEPOS_INSTALL\setup\drivers.
d. Create a subdirectory by the name of SATA.
e. Copy the SATA drivers you previously extracted into the
C:\WEPOS_INSTALL\setup\drivers\SATA subdirectory.