Table of Contents
Advertisement
5
Removal and Replacement
Procedures
This chapter provides removal and replacement procedures.
Torx and Phillips screws are removed during disassembly. There
are 57 screws, alignment pins, and standoffs, in 14 different sizes,
that must be removed, replaced, and/or loosened when servicing
the notebook. Make special note of each screw size and location
during removal and replacement.
Refer to
Appendix C, "Screw Listing"
for detailed information on
screw sizes, locations, and usage.
Maintenance and Service Guide
5–1
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the nc4010 - Notebook PC and is the answer not in the manual?
Questions and answers