Table of Contents
Advertisement
Memory module
Description
1024-MB memory module (PC2-6400, DDR2, 533-MHz)
Before removing the memory module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
If your computer has WWAN capability, remove the SIM (see
Remove the memory module:
1.
Loosen the 2 Phillips PM2.0×3.0 captive screws (1) that secure the memory module compartment
cover to the computer.
2.
Swing the cover up and away from the inside of the computer (2), and then remove the cover (3).
3.
Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The edge of the module opposite the slot rises away from the computer.)
Battery on page
35).
Spare part number
598861-001
SIM on page
36).
Component replacement procedures
37
Advertisement
Table of Contents
