Dc Connector/Power Board - Compaq Mini CQ10-100 - PC Maintenance And Service Manual

DC connector/power board

Description
DC connector/power board
Before removing the power/battery pass-through board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
If your computer has WWAN capability, remove the SIM (see
6.
Remove the following components:
a.
Keyboard (see
b.
Hard drive (see
c.
Top cover (see
Remove the power/battery pass-through board:
1. Disconnect the power cable (1).
2. Remove the 2 Phillips PM2.5×4.0 screws (2) that secure the power/battery pass-through board to
the base enclosure.
3.
Remove the power/battery pass-through board (3).
Reverse this procedure to install the power/battery pass-through board.
54 Chapter 4 Removal and replacement procedures
Battery on page 35).
Keyboard on page 39)
Mass storage devices on page
Top cover on page 45)
SIM on page
43)
Spare part number
599188-001
36).