Enterasys C5G124-24 Configuration Manual page 197

.
Procedure 12-2 SNMPv3 Configuration
Step Task
1. Create an SNMPv3 user and specify
authentication, encryption, and security
credentials.
• If remote is not specified, the user will be
registered for the local SNMP engine.
• If authentication is not specified, no
authentication will be applied.
• If privacy is not specified, no encryption will
be applied.
2. Create a user group and add the user created in
Step 1.
• If storage type is not specified, nonvolatile
will be applied.
3. Set security access rights for the group.
• If security level is not specified, no
authentication will be applied.
• Only one context, the "default context", is
supported in this release. There is no need to
configure this parameter.
• If read view is not specified none will be
applied.
• If write view is not specified, none will be
applied.
• If notify view is not specified, none will be
applied.
• If storage type is not specified, entries will be
stored as permanent and will be held through
device reboot.
4. Define views created in Step 3.
• If not specified, mask will be set to ff:ff:ff:ff.
• If not specified, subtree use will be included.
• If storage type is not specified, nonvolatile
(permanent) will be applied.
5. Set SNMP target parameters.
• If not specified, security level will be set to
noauthentication.
• If not specified, storage type will be set to
nonvolatile.
Command(s)
set snmp user user [remote remoteid]
[privacy privpassword]
[authentication {md5 | sha}]
[authpassword]
set snmp group groupname user user
security-model usm [volatile |
nonvolatile]
set snmp access groupname security-
model usm [noauthentication |
authentication | privacy] [exact |
prefix] [read readviewname] [write
writeviewname] [notify
notifyviewname] [volatile |
nonvolatile]
set snmp view viewname viewname
subtree subtree [mask mask]
[included | excluded] [volatile |
nonvolatile]
set snmp targetparams targetparams
user user security-model usm
message-processing v3
[noauthentication | authentication |
privacy] [volatile | nonvolatile]
Fixed Switch Configuration Guide 12-11
Configuring SNMP