Dart Seam; Gathering - Brother Isodore„ Innov-ís 5000 Operation Manual

Dart Seam

a
Select and attach presser foot "J".
b
Sew a reverse stitch at the beginning of the
dart and then sew from the wide end to the
other end without stretching the fabric.
* If automatic reinforcement stitching is preset, a
reinforcement stitch will automatically be sewn at
the beginning of sewing.
a Basting
c
Cut the thread at the end leaving 50 mm
(approx. 1-15/16 inches), and then tie both
ends together.
* Do not sew a reverse stitch at the end.
d
Insert the ends of the thread into the dart
with a needle.
e

Gathering

a
Use on waists of skirts, sleeves of shirts, etc.
a
b
*
c
a Upper thread
b Bobbin thread
c About 50 mm (approx. 1-15/16 inches)
SEWING THE STITCHES
Iron the dart to one side so that it is flat.
Select a straight stitch and attach presser
foot "J".
Set the stitch length to 4.0 mm (approx.
3/16 inch) and the thread tension to
approximately 2.0 (weaker tension).
If you press after pressing
stitch length will be set automatically to 4.0 mm
(approx. 3/16 inch) and the thread tension will be
automatically set to 2.0.
Pull the bobbin and upper threads out by
50 mm (approx. 1-15/16 inches) (see page
23).
a
b
c
3
, the
57