Attaching The Embroidery Unit; About The Embroidery Unit - Brother Isodore„ Innov-ís 5000 Operation Manual

BEFORE EMBROIDERING
h
Use the included screwdriver to firmly
tighten the screw of the presser foot holder.
• Use the included screwdriver to firmly tighten
the screw of the presser foot holder. If the
screw is loose, the needle may strike the
presser foot and possibly cause injury.
i
Press
buttons.

Attaching the Embroidery Unit

■ About the Embroidery Unit

• Do not move the machine with the
embroidery unit attached. The embroidery
unit could fall off and cause injury.
• Keep your hands and foreign objects away
from the embroidery carriage and frame when
the machine is embroidering. Otherwise,
injury may result.
• If the embroidery unit could not be initialized
correctly, a buzzer will sound. If this happens,
go through the initialization process again.
This is not a malfunction.
Note
• You can sew utility stitches even while the
embroidery unit is attached.
• Be sure to turn off the power before install-
ing the embroidery unit. Otherwise, the
machine may be damaged.
• Do not touch the inner connector of the
embroidery unit. The pins on the embroidery
unit connection may be damaged.
• Do not apply strong force to the embroidery
unit carriage or pick up the unit by the car-
riage. Otherwise, the embroidery unit may
be damaged.
• Store the embroidery unit in the proper stor-
age case.
128
CAUTION
to unlock all keys and
CAUTION
a
Turn the main power to OFF, and remove
the flat bed attachment.
b
Open the cover of the connection port.
Memo
Be sure to replace the cover when the embroi-
dery unit is not installed.
c
Insert the embroidery unit connection into
the machine connection port. Push lightly
until the unit clicks into place.
a Embroidery unit connection
b Machine connection port
c Feed dog position switch
Note
• Be sure there is no gap between the embroi-
dery unit and the sewing machine. If there is
a gap, the embroidery patterns will not
embroider with the correct registration.
• Do not push on the carriage when installing
the embroidery unit onto the machine. Mov-
ing the carriage may damage the embroi-
dery unit.
• Be sure to set the feed dog position switch
to right to lower the feed dogs.
b
a
c