3
Ground
4
NC
5
Ground
6
Ground
7
Fan Tach
8
Fan Power
7.13.2
Intrusion Cable Connector
7.13.3
HDD LED Header
There is a 1x2 pin Header for HDD LED Connection. This jumper reserves for PCI add-in card
which supports the SCSI or SATA interface with external HDD LED activity cable.
7.13.4
Rolling BIOS selection header
There is a 1x3 pin Header that is used to configure the function of rolling BIOS. The figure
below shows the jumper pins and their functions. The factory defaults are set to a primary BIOS
mode for each function.
Function
Pin – Pin
Rolling BIOS selection
38
Power
GROUND is the power supply ground
Power
GROUND is the power supply ground
Power
GROUND is the power supply ground
Out
FAN_TACH signal is connected to the Super IO/LM96000 to monitor the
FAN speed.
Power
Fan Power with FAN_SPEED_CNTL1 (Fan speed control)
Table 37. Intrusion Cable Connector (J1A1)Pin-Out
Pin
1
INTRUDER_N
2
GND
Table 38. HDD LED Header (J1E1) Pin-Out
Pin
1
HDD_LED_ACT_N
2
NC
Table 39. HDD LED Header (J1E1) Pin-Out
Function
1-2
Primary BIOS (Default)
2-3
Secondary BIOS
SE7221BK1-E Technical Product Specification
Signal Name
Signal Name
Although some details of this feature are described
within this manual, please refer to section 9.6.3 for
complete details.
Description