Removing And Attaching The Presser Foot Holder - Brother Innov-ís 1250D Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
GETTING READY
Removing and attaching the
presser foot holder
Remove the presser foot holder when cleaning the
sewing machine or when installing a presser foot that
does not use the presser foot holder, such as the
embroidery foot and optional quilting foot. Use the
screwdriver to remove the presser foot holder.
a Remove the presser foot.
• For details, refer to "Replacing the presser
foot" (page 44).
b Use the screwdriver to loosen the presser foot
holder screw.
a
a Screwdriver
b Presser foot holder
c Presser foot holder screw
Attaching the presser foot holder
a Raise the presser foot lever.
Align the presser foot holder with the lower-
b
left side of the presser bar.
46
b
c
Hold the presser foot holder in place with your
c
right hand, and then tighten the screw using
the screwdriver in your left hand.
1
a Screwdriver
Note
If the presser foot holder is not correctly
installed, the thread tension will be
incorrect.