Brother Innov-ís 1250D Operation Manual page 150

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
EMBROIDERY
e Loosen the presser foot holder screw and
remove the presser foot holder.
Turn the screwdriver toward the back.
a
a Screwdriver
b Presser foot holder
c Presser foot holder screw
f Hold the embroidery foot with your right
hand, as shown.
Hold the embroidery foot with your index
finger wrapped around the lever at the back of
the foot.
a Lever
g While pressing in the lever with your finger, fit
the embroidery foot bar over the needle clamp
screw to attach the embroidery foot to the
presser foot bar.
a Embroidery foot bar
b Needle clamp screw
148
b
c
1
2
h Secure the embroidery foot with the presser
foot holder screw.
Set the embroidery foot perpendicular.
i Firmly tighten the presser foot holder screw.
Turn the screwdriver toward the front.
CAUTION
Do not hit the needle with your finger or
the embroidery foot "Q" when attaching
it. The needle may break or cause injury.
Be sure to tighten the screw with the
included screwdriver. If the screw is
loose, the needle may hit the presser foot
and break or bend.
Before sewing, always turn the handwheel
toward you (counterclockwise) slowly to
make sure that the needle does not hit the
presser foot. Otherwise, the needle may
break or bend.