Brother Innov-ís 1250D Operation Manual page 99

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
e Align the seam with the center of the zipper,
and then baste the zipper in place.
a Wrong side of fabric
b Basting stiching
c Zipper
f Remove about 5 cm (2 inches) from the end of
the basting on the outside.
a Wrong side of fabric
b Zipper basting
c Outside basting
d 5 cm (2 inches)
g Attach the presser foot holder to the right pin
of zipper foot "I".
a Pin on the right side
b Needle drop point
• For details, refer to "Replacing the presser
foot" (page 44).
2
1
3
2
4
3
1
1
I
2
3
h Select stitch .
• For details, refer to "Selecting stitching" (page
51).
CAUTION
When using zipper foot "I", be sure to
select the straight stitch (center needle
position), and slowly turn the handwheel
toward you (counterclockwise) to check
that the needle does not touch the presser
foot. If a different stitch is selected or the
needle hits the presser foot, the needle
may bend or break.
i Topstitch around the zipper.
1
2
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
CAUTION
When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
j Remove the basting stitching.
3
4
Zipper Insertion 97
3