Inserting A Piping - Brother Innov-ís 1250D Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
CAUTION
After adjusting the needle position, slowly
turn the handwheel toward you and
check the needle does not touch
(counterclockwise) the presser foot. If the
needle hits the presser foot, the needle
may bend or break.
g Securely tighten the positioning screw with a
screwdriver.
1
a Positioning screw
Topstitch around the zipper.
h
1
2
a Stitching
b Right side of fabric
c Basting stitching
d End of zipper opening
CAUTION
When sewing, be sure that the needle
does not touch the zipper, otherwise the
needle may bend or break.
i Remove the basting stitching.
102
3
4

Inserting a piping

a Place the piping between two fabric pieces
turned inside out, as shown below.
a Fabric
b Piping
c Fabric
b Refer to the steps of attaching the adjustable
zipper/piping foot on the previous page.
Sew along the piping.
c
d After sewing, turn fabric pieces.
1
2
3