Viglen D865GLC - Desktop Board Motherboard Manual page 38

Table 12: Front Panel Audio Jumper Settings
Function Jumper
J9A2
Normal 5 – 6
and
9- 10
Front audio none
cable
Table 12a: Front panel Audio Connector
Pin Signal name
1 MIC_IN
3 MIC_BIAS
5 RIGHT_OUT
7 Ground
9 LEFT_OUT
CAUTION!
Do not move the jumper with the power on. Always turn off the power and unplug
the power cord from the computer before changing the jumper
Note: There is no jumper setting for configuring the processor speed or bus
frequency. The feature for configuring the processor speed is in the Setup program
using configure mode. See BIOS Section for information about configure mode.
Configuration
The audio line signals are routed back to the line connector.
Audio line out and mic in signals are available for front panel audio
connectors on this connector when no jumpers are installed.
Pin Signal name
2 Ground
4 +5V
6 RIGHT_IN
8 Key
10 LEFT_IN
D865GLC Motherboard Manual
.
37