Setting The Processor Speed - Viglen D865GLC - Desktop Board Motherboard Manual

Setting the Processor Speed

Set the processor speed after you have installed or upgraded the processor. This
procedure assumes that the motherboard is installed in the computer and the
configuration header (J9J4) has the jumper set on pins 1-2 for normal mode.
1. Observe the precautions in "Before You Begin".
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the computer cover.
4. Locate the configuration header (Figure 12, J9J4 on the motherboard).
On the header, move the jumper to pins 2-3 as shown below to set configure
5.
mode
.
6. Replace the cover, turn on the computer, and allow it to boot.
7. The computer starts the Setup program. Setup displays the Maintenance menu.
8. Use the arrow keys to select the Processor Speed feature and press <Enter>.
Setup displays a popup screen with the available processor speeds.
9. Use the arrow keys to select the processor speed. Press <Enter> to confirm the
speed. This Maintenance menu reappears again.
10. Press <F10> to save the current values and exit Setup.
11. Turn off the computer.
12. Remove the computer cover.
13. On the header (J9J4), move the jumper back to pins 1-2 to restore normal
operation as shown below.
14. Replace the cover and turn on the computer.
15. Verify the processor speed in the start-up information the BIOS displays.
Configuration Jumper
1 2 3
Configuration Jumper
1 2 3
D865GLC Motherboard Manual
J9J4
J9J4
59