Removing Dimms; Dimm Socket Locations (The D815Eea2 Board Is Shown) - Intel D815EEA2 - Desktop Board Motherboard Product Manual

Figure 4. DIMM Socket Locations (the D815EEA2 Board Is Shown)
5. Make sure the clips at either end of the DIMM socket(s) are pushed outward to the open
position.
6. Holding the DIMM by the edges, remove it from its anti-static package.
7. Position the DIMM above the socket. Align the two small notches in the bottom edge of the
DIMM with the keys in the socket (see inset in Figure 4).
8. Insert the bottom edge of the DIMM into the socket.
9. When the DIMM is inserted, push down on the top edge of the DIMM until the retaining clips
snap into place. Make sure the clips are firmly in place.
10. Replace the computer's cover and reconnect the ac power cord.

Removing DIMMs

To remove a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" (see page 25).
2. Turn off all peripheral devices connected to the computer. Turn off the computer.
3. Remove the ac power cord from the computer.
4. Remove the computer's cover.
5. Remove the AGP card (if installed).
6. Gently spread the retaining clips at each end of the DIMM socket. The DIMM pops out of the
socket.
7. Hold the DIMM by the edges, lift it away from the socket, and store it in an anti-static
package.
8. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM sockets.
9. Replace the computer's cover and reconnect the ac power cord.
Installing and Replacing Desktop Board Components
0
1
2
OM11621
27