Atapi Cdrom Drives; Exit Menu; Atapi Cdrom Drives Submenu - Intel D815EEA2 - Desktop Board Motherboard Product Manual

ATAPI CDROM Drives

To access this menu, select Boot from the menu bar, then ATAPI CDROM Drives.
Maintenance
The submenu represented in Table 30 is for setting ATAPI CD-ROM drives.
Table 30.

ATAPI CDROM Drives Submenu

Feature
st
1 ATAPI CDROM Drive
(Note)
Note: This boot device submenu appears only if at least one boot device of this type is installed. This list will display up
to four ATAPI CD-ROM drives, the maximum number of ATAPI CD-ROM drives supported by the BIOS.

Exit Menu

To access this menu, select Exit from the menu bar at the top of the screen.
Maintenance
The menu represented in Table 31 is for exiting the BIOS Setup program, saving changes, and
loading and saving defaults.
Table 31.

Exit Menu

Feature
Exit Saving Changes
Exit Discarding Changes Exits without saving any changes made in the BIOS Setup program.
Load Setup Defaults
Load Custom Defaults
Save Custom Defaults
Discard Changes
Main Advanced
Options
Dependent on installed
ATAPI CDROM drives
Main Advanced
Description
Exits and saves the changes in CMOS SRAM.
Loads the factory default values for all the Setup options.
Loads the custom defaults for Setup options.
Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory is corrupted, the BIOS reads the
custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discards changes without exiting Setup. The option values present when the
computer was turned on are used.
Security Power
Description
Specifies the boot sequence from the available
ATAPI CD-ROM drives. To specify boot sequence:
1. Select the boot device with <↑> or <↓>.
2. Press <Enter> to set the selection as the
intended boot device.
Security Power
Using the Setup Program
Boot Exit
Boot Device Priority
Hard Disk Drives
Removeable Devices
ATAPI CDROM Drives
Exit
Boot
77