Lenovo ThinkCentre A30 Quick Reference Manual page 80

charges may apply outside IBM's normal service area, contact your local IBM
representative or your reseller for country and location specific information.
1. Customer Replaceable Unit ("CRU") Service
IBM will ship CRU parts to you for your replacement. If IBM instructs you
to return the replaced CRU, you are responsible for returning it to IBM in
accordance with IBM's instructions. If you do not return the defective CRU,
if IBM so instructs, within 30 days of your receipt of the replacement CRU,
IBM may charge you for the replacement.
2. On-site Service
IBM or your reseller will either repair or exchange the failing Machine at
your location and verify its operation. You must provide suitable working
area to allow disassembly and reassembly of the IBM Machine. The area
must be clean, well lit and suitable for the purpose. For some Machines,
certain repairs may require sending the Machine to an IBM service
center.
3. Courier or Depot Service
You will disconnect the failing Machine for collection arranged by IBM.
IBM will provide you with a shipping container for you to return your
Machine to a designated service center. A courier will pick up your
Machine and deliver it to the designated service center. Following its repair
or exchange, IBM will arrange the return delivery of the Machine to your
location. You are responsible for its installation and verification. This type
of service is called ThinkPad EasyServ or EasyServ in some countries.
4. Customer Carry-In or Mail-In Service
You will deliver or mail as IBM specifies (prepaid unless IBM specifies
otherwise) the failing Machine suitably packaged to a location IBM
designates. After IBM has repaired or exchanged the Machine, IBM will
make it available for your collection or, for Mail-in Service, IBM will return
it to you at IBM's expense, unless IBM specifies otherwise. You are
responsible for the subsequent installation and verification of the Machine.
5. Limited On-site Service for selected CRUs
IBM or your reseller will perform selected CRU repairs at your request on
the following parts only: power supply, microprocessor, heat sink and
system board. IBM or your reseller will perform the repair at your location
and verify the Machine's operation. You must provide suitable working
area to allow disassembly and reassembly of the IBM Machine. The area
must be clean, well lit and suitable for the purpose. For some Machines,
certain repairs may require sending the Machine to an IBM service
center.
6. Limited Courier or Depot Service for selected CRUs
In the event of the failure of your IBM Machine's power supply,
microprocessor, heat sink or system board, you will disconnect the failing
Machine for collection arranged by IBM. IBM will provide you with a
shipping container for you to return your Machine to a designated service
54
Quick Reference