Section 2. Installing Sco Unixware 2 - HP D7171A - NetServer - LPr Introduction Manual

Section 2. Installing SCO UnixWare 2.1.x
Large Memory Access
SCO UnixWare 2.1.x can access a maximum of 2 GB physical memory (RAM). By
default UnixWare will not see more than 128 MB of RAM. If your system has between
128 MB and 2 GB of RAM you will need to modify the "/stand/boot" file as follows.
Add the following entry to /stand/boot:
MEMRANGE=0-640K:256,1M-16M:512,16M-nnM:8704
where "nn" is the total memory size (in MegaBytes).
See the man page for "boot" for a description of the MEMRANGE option. Edit the
/stand/boot file very carefully since an error in the file may prevent your system from
booting.
SCSI Extended Translation Setting
The SCSI extended translation setting for disks with a capacity larger than 1 GB should
be set to 'disabled' for all versions of SCO UnixWare. (Run the EISA Configuration
Utility or the SCSI BIOS <cntl>-A to set this parameter.)
MPS Table Setting On NetServer LS and LX for SCO MPX
For the HP NetServer LS and LX with multiprocessors, you must set the MPS
configuration parameter to the correct MPS Table setting.
1. Run the EISA Configuration Utility.
2. Move to the MPS Table selection.
3. Select the MPS table value 1.1 for SCO UnixWare 2.0x. Select MPS table value 1.4
for SCO UnixWare 2.1.x.
HP Bundled NICs Not Supported On UnixWare 2.1.x
The Network Interface Cards (NICs) that are bundled in some HP NetServer models do
not have drivers for UnixWare 2.1.x at this time. Consult SCO's hardware compatability
guide for a supported NIC.
Installing SCO UnixWare 2.1.x
The following instructions help you to install SCO UnixWare 2.1.x on your HP
NetServer system.
NOTE: In general, UnixWare can not share IRQs across different types of
controller cards.