Troubleshooting - HP D7171A - NetServer - LPr Introduction Manual

NetServer
E 30,40,45
LC Plus
LC II,3
LD Pro
LH
LH Plus, LH Pro
LH II,3
LS
LX, LXe, LXr Pro
LPr
LH3,LH4,
LC 2000
LH 3000
LH 6000
LT 6000r
NOTE: HP currently does not support ultra SCSI mode on the AIC7880
controllers when they are connected to the HP Storage System 6. Ultra SCSI
mode is supported for disks installed in the HP NetServer cabinet.

Troubleshooting

SCO UnixWare is very specific about the hardware configuration it expects when
installing. The following limitations apply:
The root hard disk and the install device should both be on the primary SCSI channel.
The root hard disk must be SCSI ID 0. The first SCSI tape drive must be SCSI ID 2.
The first SCSI CD-ROM drive must be SCSI ID 5.
The correct SCSI ID is especially important if you are installing from the tape or CD-
ROM drive. If you have a complicated hardware configuration, install SCO
UnixWare using only the minimum system required to install. All additional
hardware can be added afterwards.
Controller Package Name
AHA2910 adsl
AIC7770 adsa
AIC7880 adsl
AIC7880 adsl
AIC7855 adsl
AIC7880 adsl
AIC7880 adsl
AIC7870 adsl
AIC7880 adsl
Symbios895 c8xx
Symbios895 c8xx
NetRaid 3Si mega
Symbios895 slha & mega
Symbios896 slha & mega
Symbios896 slha & mega
Symbios896 slha & mega