Replacing The Covers; Hp Netserver Lh 3; Hp Netserver Lh 3R - HP D7171A - NetServer - LPr Installation Manual

Power supply upgrade kit

Hide thumbs Also See for D7171A - NetServer - LPr:

Table of Contents

Chapter 3

Replacing the Covers

After installing the power supply and fan module, replace the covers and bezel.

1. Insert the tabs inside cover 1 into the slots in the chassis and slide the side

cover toward the rear. Tighten the thumbscrew at the front of the cover.

Repeat this step for cover 3.

2. To replace the bezel, insert the tabs at the bottom of the bezel into the

slots at the bottom of the chassis front and press the top of the bezel to the

chassis until it snaps into place. Lock the bezel lock with the key

provided.

3. Replace all power, telephone, and I/O cables.

4. Push the anti-tip foot in.

1. Insert the tabs inside Cover 1 into the slots in the chassis and slide the

cover toward the rear. Tighten the thumbscrew at the front of the cover.

Repeat this step for Cover 3.

2. Unlock the rail locks and slide the NetServer back into the rack chassis.

3. Reinstall the latch plate, bezel hinge, and bezel (see Figure 1-2).

4. Replace all power, telephone, and I/O cables.

Installing the Fan Module

Table of Contents